CPE Rubber Hose & Fittings

Designed for motorsport and fast road use, the CPE is perhaps the most widely used range of lines and fittings. The CPE hose is a true double braided stainless hose that uses the highest quality stainless wire available. The hose is constructed with a Stainless Steel outer braid resisting abrasion and corrosion. Combined with a reinforced CPE synthetic inner rubber lining with a Nylon Inner braid, the hose is compatible with all synthetic lubricants, oils, fuels and coolants (including methanal and nitromethane).

Filter By

Frequently Asked Questions

Can I use rubber hose for fuel lines?

Absolutely, they run at lower pressures than PTFE Lined hoses so check this before deciding to use the rubber lined hose.

What size ID is obp fuel hose?

The IDs are as follows:
AN4 – 5.4mm
AN6 – 8.7mm
AN8 – 11.10mm
AN10 – 14.20mm
AN12 – 17.40mm
AN16 – 22.20mm

What is the difference between CPE and PTFE fuel hose?

PTFE hose tends to run at higher pressures that CPE Lines. Both can do the same job though! The PTFE Fuel hose is always recommended if the fuel lines are running through the cabin of the vehicle as they trap the fuel vapour!

What fittings do I need for CPE Fuel Hose?

You are only able to use the CPE Specific fittings. PTFE End Fittings have a small olive inside that is crushed upon fitment whereas the CPE does not have this.